Assembling and Fabrication: Career and Education Opportunities in Thornton, Colorado
Assembling and Fabrication: Fabricators and Assemblers form and assemble the products that are built on a factory floor. Working with electronics, metals and plastics, their work turns parts into products.
Thornton is located in Adams County, Colorado. It has a population of over 113,429, which has grown by 37.7% over the last ten years. The cost of living index in Thornton, 94, is below the national average. New single-family homes in Thornton are priced at $176,300 on average, which is far less than the state average. In 2008, two hundred ninety-five new homes were constructed in Thornton, down from four hundred eighty-four the previous year.
The three big industries for women in Thornton are educational services, health care, and finance and insurance. For men, it is construction, professional, scientific, and technical services, and administrative and support and waste management services. The average commute to work is about 29 minutes. More than 19.9% of Thornton residents have a bachelor's degree, which is lower than the state average. The percentage of residents with a graduate degree, 4.8%, is lower than the state average.
The unemployment rate in Thornton is 6.3%, which is less than Colorado's average of 6.6%.
The percentage of Thornton residents that are affiliated with a religious congregation, 30.4%, is less than both the national and state average. The largest religious groups are the Catholic Church, the LDS (Mormon) Church and the Lutheran Church.
Featured Online Colleges
CAREERS WITHIN: Assembling and Fabrication
Electrical and Electronic Equipment Assemblers assemble or modify electrical or electronic equipment, such as computers, test equipment telemetering systems, electric motors, and batteries. Electrical and Electronic Equipment Assemblers need to determine which tools and techniques should be applied to solve a problem or deal with a situation. They also need to test products and systems both during and after development to evaluate and catch faults as they occur.
Structural and Ornamental Metalwork Metal Fabricators fabricate, lay out, and fit parts of structural metal products. Structural and Ornamental Metalwork Metal Fabricators need to test products and systems both during and after development to evaluate and catch faults as they occur. They also need to respond to the actions of other and coordinate activities with them.